Making “flange” or “edges” on the metal sheets, especially on the thinner ones, is very common. There are different reasons for making these “flattened bends” and the most common are: – Give a better finish to the...
Stainless steel sheet of 3 m/m with protection, with marks Stainless steel sheet of 3m/m with bending marks Stainless steel sheet of 3 m/m without bending marks In the 21st century, it is no longer necessary to say how important quality is in all the products that are...
This video is based on a real case that happened following a question from one of our costumers: How to avoid that the holes get deformed near the bending area? In this case it was a metal sheet of 6m / m. We gave him the most suitable solution for these cases; The...
The lacquering of aluminum consists of the electrostatic application of a powder paint to the surface of the aluminum. The paints used for this finish are polyester or polyurethane resins and this gives them great resistance to UV rays, atmospheric agents and...
How can I bend Z-shaped metal sheet? Many customers ask us the different methods and systems that exist to make “Z” shaped bends with a press brake and what type of bending tools are needed. In the next post we will see the three main methods that exist as...
HOW TO TURN THE PUNCH IN A PRESS BRAKE WITH PROMECAM MOORING? Many customers ask us how they can turn the punch with the Promecam mooring system in their metal sheet press brake. Since, sometimes due to the design or configuration of the piece to be folded, they need...
