The PNEUMATIC HAMMER is ideal for separating parts cut by laser,...
The 120x120 MAGNETIC TEMPLATE makes it possible to make bends (with the...
MQ Cleaner Laser1020, Laser Slag Cleaner for cleaning laser slag. With...
The i-LASER LINE 30mW draws a visible Laser Line of more than 6 meters...
The ADJUSTABLE SUPPORTING ARM allows the i-LASER LINE 30mW to be...
The NOVA-ELECTRONICA Support allows the i-LASER LINE 30mW to be...
The AKAS Support allows the i-LASER LINE 30mW to be installed under the...
The left magnetic square PLUS allows you to square the sheet and also...
The right magnetic square PLUS allows you to square the sheet and also...
Cutting and squaring of punches, dies and bending tools. The cut is made and then the two cut faces are squared, to guarantee a perfect alignment. In the COMMENTS area (at the end of the order) you must indicate the desired measures, considering that the cutting + squaring there is usually a lost of 5 m/m (as seen in the attached example). EXAMPLE OF CUT:
Milling of punches and dies, to avoid collisions with the metal sheet. The price is per meter or section of punch or die (in case of being a fractionated it is counted as two units). It is recommended to contact our Technical Office, to carry out the feasibility study and calculate the strength of the tool once modified. Or sending the profile via email...
Rectification of punches, change of radius or angle. The price is per section of 835 m/m or 1.020 m/ m of punch. It is recommended to contact our Technical Office, to see if the rectification is feasible.
Rectification of blades. The price is for each meter of rectified blade. We always rectify the 4 faces so that there is an optimum grinding. If in a lip of the blade there is a very large deterioration, it will be unused and that face will be rectified superficially.
Laser marking of measurements, codes, references, etc., upon request. The price is per marked unit.